Idec DATAVS1 Series Uživatelský manuál stáhnout pdf (Strana 69)

Instruction Manual SVS1 Series

8. TEACH BUTTON

The Teach button located on the upper part of the sensor allows you to reboot the device in Recovery

mode. This function is needed to update the firmware of the sensor.

To enable the recovery procedure, boot the device whilst holding the TEACH button down until the

output LEDs (the two central ones) start to flash; this means the sensor is loading its recovery software.

Using the software supplied with the update kit, it is then possible to connect the sensor to the PC and

enable the update procedure. Please refer to the manual supplied with the Kit for further details.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 82 83

Žádné komentáře

Idec DATAVS1 Series Uživatelský manuál Strana 69